Please read this manual carefully before using the splitter, which will make your machine run safely and smoothly. This machine is only used to separate the circuit board through the V notch. Don't use it for other purposes. Do not, under any circumstances, remove the protective plate around the blade of the splitter to avoid danger. During operation, do not wear loose clothes and wear long hair to avoid being involved in the machine. According to the thickness of the circuit board, the height of the upper blade can be adjusted by the upper blade height adjustment knob. Make sure that the parts on the circuit board will not collide with the fuselage and blades. The relevant dimensions of the splitter are shown in the figure. The height of the parts on the circuit board shall not exceed the range shown in the figure. If the parts on the circuit board touch the blade, please contact our company to have the blade specially machined to avoid cutting the parts.

Before using the splitter, check the contents of the box, including the following parts: main engine, manual, power cord, and hex wrench, for adjustment. After confirming that the power supply voltage is correct, switch on the power supply and start. Adjust the tray to the proper height according to the height of the parts on the circuit board and tighten it with the included Allen wrench. To prevent static electricity from damaging components on the circuit board, the machine must be grounded reliably. If the ground wire in the power socket is reliable and effective, it is reliably grounded when the distributor is powered on. Remove the packaging bag of the machine, place the machine on a flat solid workbench, and wipe off the rust grease on the blade of the machine.

Welcome to call Hangzhou Yixie Intelligent Equipment Co., LTD., we specialize in the production of automatic dividing machine, milling cutter dividing machine, online dividing machine, sincerely welcome new and old customers to inquire and buy